DigitalEdgeArmStartTrigger Properties
- Updated2023-02-21
- 2 minute(s) read
DigitalEdgeArmStartTrigger Properties
The DigitalEdgeArmStartTrigger type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
 | DigitalFilterEnable | Specifies whether to apply the pulse width filter to the signal. |
| DigitalFilterMinimumPulseWidth | Specifies in seconds the minimum pulse width the filter recognizes. |
| DigitalFilterTimebaseRate | Specifies in hertz the rate of the pulse width filter timebase. NI-DAQmx uses this value to compute settings for the filter. |
| DigitalFilterTimebaseSource | Specifies the input terminal of the signal to use as the timebase of the pulse width filter. |
| DigitalSynchronizationEnable | Specifies whether to synchronize recognition of transitions in the signal to the internal timebase of the device. |
| Edge | Specifies on which edge of a digital signal to arm the task for a Start Trigger. |
| Source | Specifies the name of a terminal where there is a digital signal to use as the source of the Arm Start Trigger. |