ExternalCalibrationSession.Setup9264 Method
- Updated2023-02-21
- 1 minute(s) read
ExternalCalibrationSessionSetup9264 Method
Writes the specified binary value to the DAC on the specified physical channel. This method requires a sweep of DAC values obtained from Get9264AdjustmentPoints.
Namespace: NationalInstruments.DAQmx
Assembly: NationalInstruments.DAQmx (in NationalInstruments.DAQmx.dll) Version: 20.7.40.49302
Syntax
public void Setup9264( string physicalChannels, int value )
Public Sub Setup9264 ( physicalChannels As String, value As Integer )
Parameters
- physicalChannels
- Type: SystemString
Specifies the name of the physical channel to use to create the virtual channel. The DAQmx physical channel constant lists all physical channels for devices installed in the system. You cannot specify more than one physical channel. - value
- Type: SystemInt32
The binary number to write to the DAC.
Exceptions
| Exception | Condition |
|---|---|
| DaqException | The NI-DAQmx driver returned an error. |
Remarks
Refer to the calibration procedure for your device for detailed calibration instructions.
 Note |
|---|
| After you commit the calibration, you cannot undo it. If any calibration settings are incorrect, you must recalibrate the device. |