Configuring ADC Calibration
- Updated2023-05-10
- 1 minute(s) read
Configuring ADC Calibration
Configure ADC calibration by completing the following steps:
- LabVIEW
- Insert niDMM Configure ADC Calibration into the block diagram.
- Set ADC Calibration to the desired input value (refer to the following table).
- CVI/C++/Visual Basic
- Insert niDMM_ConfigureADCCalibration into the program.
- Set ADC Calibration to the desired input value (refer to the following table).
| Values | Description |
|---|---|
| Values | Description |
| AUTO (-1) | The driver chooses the ADC calibration setting based on the configured function and resolution. |
| ON (1) | Enables ADC Calibration. |
| OFF (0) | Disables ADC Calibration. |
Note This feature is supported on the NI 4080/4081/4082 and the NI 4070/4071/4072.