The PXIe-5654 hardware is in the following state after powering on or restarting the system and allowing the PC operating system and NI-RFSG to fully load. These conditions are also true after a device reset that you perform directly from NI Measurement & Automation Explorer (MAX).
  • The RF analog signal generator frequency is set to 1 GHz.
  • The RF analog signal generator power level is set to -7 dBm.
  • The RF output signal is off.
  • The REF IN connector is set to use the internal frequency reference.
  • The REF OUT connector is set to off.
  • The REF OUT 2 connector is set to off.
  • The TRIG IN/OUT connector is configured as in input.
  • The AM IN connector is set to off.
  • The FM IN connector is set to off.
  • The PULSE IN connector is set to off.
  • The ALC is disabled.
  • Thermal shutdown monitoring is activated.

PXIe-5654 with PXIe-5696 Power On and Reset Conditions

The PXIe-5654 RF Analog Signal Generator with the PXIe-5696 Amplitude Extender is in the following state after powering on or restarting the system.

  • The mechanical attenuator is set to a maximum attenuation of 110 dB.
  • The RF signal generator frequency is set to 1 GHz.
  • The RF signal generator power level is set to -110 dBm.
  • The RF output signal is off.
  • The REF IN connector is set to use the internal frequency reference.
  • The REF OUT connector is set to off.
  • The REF OUT 2 connector is set to off.
  • The TRIG IN/OUT connector is configured as in input.
  • The AM IN connector is set to off.
  • The FM IN connector is set to off.
  • The PULSE IN connector is set to off.
  • The ALC is disabled.
  • Thermal shutdown monitoring is activated.

The PXIe-5654 with PXIe-5696 returns to the power-on state after a device reset that you perform directly from Measurement & Automation Explorer (MAX).