Running a Test
- Updated2025-03-26
- 1 minute(s) read
Running a Test
Use your configured FlexLogger project to run tests and log data.
-
Click RUN to run a test and start logging data.
FlexLogger starts logging your test data based on your data logging configuration.
Note All channels are logged except output, variable, and System Resource Monitor channels,
which cannot be logged
-
To pause a running test, click Pause test (
).
When you pause a test, you temporarily suspend data logging, data logging triggers, and time-based events.
Note Value-based events continue running
while a test is paused. For more information, refer to Adding an
Event.
- To resume a paused test, click Resume test.
- To stop a running test, click STOP.
Related Information
- Configuring Device Channels
Before you can start your test and log data, add sensors and signals to your Channel Specification. Learn about the different ways you can configure device channels.
- Defining Your Test Configuration
Set the conditions and logging behavior of your project.
- Adding an Event
Use the Test Specification to create an event trigger to generate a response from your system.