PXIe-8361 Specifications

Definitions

Warranted specifications describe the performance of a model under stated operating conditions and are covered by the model warranty.

Characteristics describe values that are relevant to the use of the model under stated operating conditions but are not covered by the model warranty.

  • Typical specifications describe the performance met by a majority of models.
  • Nominal specifications describe an attribute that is based on design, conformance testing, or supplemental testing.
  • Measured specifications describe the measured performance of a representative model.

Specifications are Typical unless otherwise noted.

Conditions

This document lists the system specifications for the PXIe-8361 (115760Ax-01L) only.

Note The specific NI assembly number in parentheses follows the model number. Ensure the specifications of interest match the NI assembly number on either the front or back side of the module. x denotes all letter revisions of the assembly.

Specifications are typical at 25 °C unless otherwise noted, and are subject to change without notice.

PXIe-8361 Pinout

Use the pinout to connect to terminals on the PXIe-8361.

Figure 1. PXIe-8361 connector pinout


Table 1. Signal descriptions
Pin Number Signal Description Note
A1 PERn0 Differential PCI Express receiver lane —
A2 PERp0 —
A3 RSVD Reserved NC
A4 SB_RTN Signal return for single-ended sideband signals —
A5 CREFCLKn Differential 100 MHz cable reference clock —
A6 CREFCLKp —
A7 PWR_RTN Return for +3.3 V power NC
A8 CPERST# Cable PERST# —
A9 GND Ground reference for PCI Express transmitter lane —
B1 GND Ground reference for PCI Express receiver lane —
B2 RSVD Reserved NC
B3 CWAKE# Power management signal for Wakeup events (optional) —
B4 CPRSNT# Detects the following:
  • whether a cable is installed
  • whether the downstream subsystem is powered
—
B5 GND Ground reference for cable reference clock —
B6 PWR +3.3 V power NC
B7 CPWRON Upstream subsystem Power Valid notification —
B8 PETn0 Differential PCI Express transmitter lane —
B9 PETp0 —
NC = no connection

Physical

Dimensions (L×W) 10.0 cm × 16.0 cm (3.9 in. × 6.3 in.)
Maximum cable length 7 m (23 ft)
Slot requirements One PXI Express system slot
Compatibility Fully compatible with the PXI-5 Express Hardware Specification, Revision 1.0
Weight 0.16 kg (0.35 lb) typical

Power Requirements

Power Rail Typical Current Maximum Current
+3.3 V 750 mA 1.2 A
+5 V 1 A 25 mA
+12 V 300 mA 800 mA
+5 VAUX 110 mA 300 mA

Environmental Characteristics

Temperature

Operating 0 °C to 55 °C
Storage -40 °C to 71 °C

Humidity

Operating 10% to 90%
Storage 5% to 95%

General environmental

Pollution Degree 2
Maximum altitude 2,000 m (800 mbar) (at 25 °C ambient)
Note Clean the PXIe-8361 with a soft nonmetallic brush. Make sure that the device is completely dry and free from contaminants before returning it to service.

Shock and vibration

Operating vibration 5 Hz to 500 Hz, 0.3 g RMS
Non-operating vibration 5 Hz to 500 Hz, 2.4 g RMS
Operating shock 30 g, half-sine, 11 ms pulse