Installing the PXIe-4468 into a Chassis

Notice To prevent damage to the PXIe-4468 caused by ESD or contamination, handle the module using the edges or the metal bracket.
  1. Ensure the AC power source is connected to the chassis before installing the module.
    The AC power cord grounds the chassis and protects it from electrical damage while you install the module.
  2. Power off the chassis.
  3. Inspect the slot pins on the chassis backplane for any bends or damage prior to installation. Do not install a module if the backplane is damaged.
  4. Position the chassis so that inlet and outlet vents are not obstructed.
    For more information about optimal chassis positioning, refer to the chassis documentation.
  5. Remove the black plastic covers from all the captive screws on the module front panel.
  6. Identify a supported slot in the chassis. The PXIe-4468 module can be placed in PXI Express hybrid peripheral slots (1378), PXI Express system timing slots (1378), or PXI Express peripheral slots (1378).
  7. Touch any metal part of the chassis to discharge static electricity.
  8. Ensure that the ejector handle is in the downward (unlatched) position.
    Figure 3. Module Installation

    1378

  9. Place the module edges into the module guides at the top and bottom of the chassis. Slide the module into the slot until it is fully inserted.
  10. Latch the module in place by pulling up on the ejector handle.
  11. Secure the module front panel to the chassis using the front-panel mounting screws.
    Note Tightening the top and bottom mounting screws increases mechanical stability and also electrically connects the front panel to the chassis, which can improve the signal quality and electromagnetic performance.
  12. Cover all empty slots using either filler panels (standard or EMC) or slot blockers with filler panels, depending on your application.
    Note For more information about installing slot blockers and filler panels, go to ni.com/r/pxiblocker.
  13. Power on the chassis.