Configure Trigger Slope
- Updated2023-02-17
- 2 minute(s) read
Configure Trigger Slope
Sets the trigger slope to either rising edge (positive) or falling edge (negative) polarity.
Inputs/Outputs
session in
Instrument identifier from previous NI-DMM nodes.
Default value: None
slope
Polarity of the trigger signal on which the measurement is triggered.
NI-DMM sets the Trigger Slope property to this value.
Rising Edge | The driver triggers on the rising edge of the trigger signal. The Trigger Slope property is set to POSITIVE. |
Falling Edge | The driver triggers on the falling edge of the trigger signal. The Trigger Slope property is set to NEGATIVE. |
Default value: Falling Edge
error in
Error conditions that occur before this node runs.
The node responds to this input according to standard error behavior.
Default value: No error
session out
Instrument identifier for subsequent NI-DMM nodes.
error out
Error information.
The node produces this output according to standard error behavior.