System Reset Options

The following table lists the reset options available on the cRIO-9082. These options determine how the system behaves when the controller is reset in various conditions. Use the RIO Device Setup utility to select reset options. Launch the RIO Device Setup utility by selecting Start » All Programs » National Instruments » NI-RIO » RIO Device Setup.

Table 3. cRIO-9082 Reset Options
Chassis Reset Option Behavior
Do not autoload VI Does not load the FPGA bit stream from flash memory.
Autoload VI on device powerup Loads the FPGA bit stream from flash memory to the FPGA when the controller powers on.
Autoload VI on device reboot Loads the FPGA bit stream from flash memory to the FPGA when you reboot the controller either with or without cycling power.