I am using C Series analog input modules with Delta-Sigma (DSA) and successive approximation register (SAR) ADC types with my cRIO. How can I synchronize these two types of modules together in FPGA?

The compliance voltage provided in specification sheet is stated as minimum. What is the maximum compliance voltage?

I am acquiring a signal from accelerometer using DAQmx Read.vi and presenting it as analog waveform 1 channel N samples and I am also calculating RMS value of the acquired signal. After that I am saving ...

At a higher level, the specifications of the NI 9233 and NI 9234 seem to be quite similar. What are some of the key differences between both modules?

I have a DAQmx device connected to my computer or housed in a cDAQ or PXI chassis, and NI Measurement and Automation Explorer (MAX) shows the device is not supported anymore. Status Code: -209852 The ...

When I attempt to read or configure transducer electronic data sheets(TEDS) for the sensors connected to my NI dynamic signal acquisition (DSA) device it can take anywhere from a couple of seconds to several ...

Why do some IEPE and ICP sensors specify Excitation Voltage, and how does that relate to the Compliance Voltage specification for NI IEPE products like the NI 4461, NI 4462, NI 4464, NI 4492, NI 9230, ...

I am using an NI DAQ device and need to programmatically enable IEPE excitation. How do I do this? How do I change the coupling type for my IEPE excitation? I am using NI 9234 module in FPGA mode. How ...

Is it possible to trigger acquisitions with the NI-9233 and NI-9234?

I have a DAQ card or module, and I would like to test it to make sure that it is fully functional and within its specification limits. How can I do this quickly?