Supported Hardware for NI-Embedded CAN for RIO

The NI-Embedded CAN for RIO software supports the following NI hardware products:

• NI roboRIO 2.0 - NI-RIO 21.0 or Later and LabVIEW 2019 or later required.

• NI roboRIO - NI-RIO 14.0 or later and LabVIEW 2014 or later required.
  

• Onboard CAN interfaces of Single-Board RIO-9607/9627/9637 — NI-RIO 15.0 or later and LabVIEW 2015 or later required.

• NI sbRIO-9651 System on Module (SOM) Development Kit (no longer sold) — NI-RIO 14.0 or later and LabVIEW 2014 or later required.

• Onboard CAN interfaces of Single-Board RIO-9623/9626/9633/9636 — NI-RIO 12.0 or later and LabVIEW 2012 or later required.
  

• Onboard CAN interfaces of Single-Board RIO-9605/9606 — NI-RIO 4.0 or later and LabVIEW 2011 or later required.

The NI-Embedded CAN for RIO software supports a partial list of the Single-Board RIO hardware. Refer to Software Support for CompactRIO, CompactDAQ, Single-Board RIO, R Series, and EtherCAT for information about software support.