NI does not actively maintain this document.
This content provides support for older products and technology, so you may notice outdated links or obsolete information about operating systems or other relevant products.
ID | Known Issue | |||||
---|---|---|---|---|---|---|
346602 | Switching from Ref In to Clk In when there is no signal on Clk In for the NI PXIe-5673E causes the device to enter an unknown state If you configure the NI PXIe-5673E to use the Ref In as the Reference Clock source then change the Reference Clock source to Clk In, a message prompts you to connect a clock source to Clk In of Arb. When you cancel the message, the following error results: Error: The AWG reported the following error: PLL could not phase-lock to the external reference clock. Make sure your reference clock is connected and that it is within the jitter and voltage specifications. Changing a parameter value clears the error message, but the device remains in an error state. Workaround: Click the Preset button or close and reopen the device session.
| |||||
369497 | Incorrect behavior occurs when you load an I/Q file with invalid arguments Loading an I/Q text file with an incorrect array type may force the NI-RFSG SFP to close the current device session or cause the RF On/Off button to stay ON as the NI-RFSG SFP returns an error. If you click the RF On/Off button, the error is removed, but no output signal is generated. Workaround: Reopen the session if needed, then load the I/Q file, or disable Arb mode to generate a signal at the output.
| |||||
372625 | NI-RFSG SFP does not clear PLL lock errors When disconnecting an external Reference Clock, the NI-RFSG SFP returns an error. When you reconnect an external Reference Clock, you must change a setting on the NI-RFSG SFP, such as the frequency setting, in order for the NI-RFSG SFP to attempt to sync to the Reference Clock. Workaround: N/A
| |||||
450527 | An error occurs when you re-enable Arb mode after saving the NI-RFSG SFP configuration When the NI-RFSG SFP is generating in Arb mode and you save the configuration, disabling and then re-enabling Arb mode returns an error. The NI-RFSG SFP continues to generate a signal as if Arb mode is disabled. Workaround: Reload the I/Q file to clear the error, or toggle the RF On/Off button to clear the error.
| |||||
345543 | The splash screen disappears before the NI-RFSG SFP finishes launching When you launch the NI-RFSG SFP and select a device, there may be a delay of five or more seconds after the splash screen disappears and before the SFP appears. Workaround: N/A
| |||||
344365 | Help»NI-RFSG SFP Help opens the Devices topic in the NI RF Signal Generators Help When you select Help»NI-RFSG SFP Help, the help viewer opens to the Devices topic of the NI RF Signal Generators Help. Workaround: Select Help»NI-RFSG SFP Help. In the Contents tab of the NI RF Signal Generators Help, open the NI-RFSG Soft Front Panel Help book, located below the Devices book, to view the Soft Front Panel help.
|
Related Topic: