Positioning Your TestScale Modules

TestScale I/O and power modules can be installed in any numbered slot (1 through 5). The core module must be installed in the core module slot (Core Slot/slot C) of the backplane.
Note The slot designations are denoted on the backplane and front panel (as shown in the following figure). In side- and bottom-mounting in-fixture configurations (TS-15000) and rackmount (TS-15010) configurations, the front panel is installed on the module I/O connectors and denotes the module slots on the front of the backplane. For direct mounting, the modules will install directly onto a custom interface board and do not require the front panel. Follow the same positioning guidelines when installing modules into your custom fixture.
Figure 3. TestScale Backplane Front Panel Module Slots

1378

Your TestScale system configuration should account for the power requirements of the modules in your application. Refer to the Power Considerations topic for additional information.