USB Port

With the Timing and Synchronization upgrade, the PXIe-1095 has a single USB 3.0 Type A port on the rear of the chassis. The following table lists and describes the USB 3.0 connector signals.

Table 10. USB 3.0 Connector Signals
Pin Signal Name Signal Description
1 VBUS Cable Power (+5 V)
2 Data- USB Data–
3 Data+ USB Data+
4 GND Ground
5 StdA_SSRX– USB Data Receive–
6 StdA_SSRX USB Data Receive+
7 GND DRAIN Ground
8 StdA_SSTX– USB Data Transmit–
9 StdA_SSTX+ USB Data Transmit+

The PXIe-1095 chassis uses a Texas Instruments TUSB7340 USB 3.0 Host Controller as the interface for the rear USB port.

Note Drivers for this device are required for Windows 7 and are available for download at www.ti.com/lit/zip/sllc423.