RfsgWarning Properties
- Updated2024-05-08
- 6 minute(s) read
RfsgWarning Properties
The RfsgWarning type exposes the following members.
Properties
| Name | Description | |
|---|---|---|
  | ArbOverflowDigitalGainWarningCode |
Gets the warning code when overflow is detected in the Arb's digital gain circuit.
|
| AwgWarningCode |
Gets the warning code from AWG.
|
| BandwidthExceededWarningCode |
Gets the warning code when signal bandwidth exceeds FIR filter passband bandwidth.
|
| CicFilterOverflowWarningCode |
Gets the warning code when overflow is detected in the Arb's CIC filter and output waveform was clipped.
|
| Code |
Gets the error code that is assigned to the warning.
|
| CoercedIQRateNotReadWarningCode |
Gets the warning code when the IQ rate was coerced, but coerced IQ rate is not read.
|
| CompensationLimitedWarningCode |
Gets the warning code when the thermal correction has reached its limit.
|
| FirFilterOverflowWarningCode |
Gets the warning code when overflow is detected in the Arb's FIR Filter.
|
| InaccurateTemperatureWarningCode |
Gets the warning code when more variation in the readings is found than expected while averaging temperature sensor readings.
|
| IncompatibleFileVersionWarningCode |
Gets the warning code when the file version is not fully compatible with this driver.
|
| InternalWarningCode |
Gets the warning code for an internal warning.
|
| InvalidAttenuatorWarningCode |
Gets the warning code when attenuator hold is enabled, but the held attenuator combination is not calibrated at the new frequency.
|
| InvalidAttributeNameWarningCode |
Gets the warning code when the attribute name in the file was not recognized or is not supported.
|
| InvalidCalibrationConstantsWarningCode |
Gets the warning code when Calibration constants are invalid.
|
| InvalidWaveformFilepathWarningCode |
Gets the warning code when the waveform filepath is invalid.
|
| IQSumOverflowWarningCode |
Gets the warning code when the Arb's OSP circuit detected an overflow due to an IQ pair with an absolute value greater than 1.0. |
| LOWarningCode |
Gets the warning code from LO.
|
| Message |
Gets or sets the message that describes the warning.
|
| NotPhaseContinuousWarningCode |
Gets the warning code when output signal is not be phase continuous.
|
| OutOfRangeWarningCode |
Gets the warning code when the specified value is outside the valid range and device performance is not guaranteed.
|
| OutOfSpecificationUserSettingWarningCode |
Gets the warning code when the requested property value exceeds device specification limits.
|
| PowerLevelInaccuracyWarningCode |
Gets the warning code when unable to correct for temperature deviation.
|
| PowerOutOfRangeWarningCode |
Gets the warning code when attenuator hold is enabled, and the requested power level is out of range for the selected attenuator.
|
| ReadAndDownloadUnsuccessfulWarningCode |
Gets the warning code when reading the waveforms from a TDMS file is unsuccessful.
|
| ReversePowerProtectionWarningCode |
Gets the warning code when the specified value is outside the valid range.
|
| SignalOutsidePassbandWarningCode |
Gets the warning code when the signal is outside of the upconverter passband.
|
| UnexpectedDriverWarningCode |
Gets the warning code for an unexpected driver warning.
|
| UpconverterWarningCode |
Gets the warning code from Upconverter.
|