RfsgArb.WriteWaveform Method (String, Double[], Double[], Boolean)

public void WriteWaveform(
	string name,
	double[] iData,
	double[] qData,
	bool moreDataPending
)

Public Sub WriteWaveform ( 
	name As String,
	iData As Double(),
	qData As Double(),
	moreDataPending As Boolean
)

Parameters

name

Type: SystemString
Specifies the name used to identify the waveform. This string is case-insensitive and alphanumeric, and it does not use reserved words.

iData

Type: SystemDouble
Specifies the in-phase (I) component of the complex baseband signal.

qData

Type: SystemDouble
Specifies the quadrature (Q) component of the complex baseband signal.

moreDataPending

Type: SystemBoolean
Specifies whether or not the data block contains the end of the waveform. Set this parameter to TrueString to allow data to be appended later to the waveform. Splitting the waveform into multiple data blocks can reduce the memory requirements of the write operation. Append data to a previously written waveform by using the same waveform in the name parameter. Set moreDataPending to FalseString to indicate that this data block contains the end of the waveform. If the waveform is already allocated, this parameter is ignored.

The NI-RFSG must be in the Configuration state before you call the WriteWaveform(String, Double, Double) method.

Reference