Electromagnetic Compatibility Guidelines

This product was tested and complies with the regulatory requirements and limits for electromagnetic compatibility (EMC) stated in the product specifications. These requirements and limits provide reasonable protection against harmful interference when the product is operated in the intended operational electromagnetic environment.

This product is intended for use in industrial locations. However, harmful interference may occur in some installations, when the product is connected to a peripheral device or test object, or if the product is used in residential or commercial areas. To minimize interference with radio and television reception and prevent unacceptable performance degradation, install and use this product in strict accordance with the instructions in the product documentation.

Furthermore, any changes or modifications to the product not expressly approved by National Instruments could void your authority to operate it under your local regulatory rules.

Caution To ensure the specified EMC performance, operate this product only with shielded cables and accessories. The DC power input cables and optical SFP+ cables may be unshielded.
Caution To ensure the specified EMC performance, you must use an isolated cable with the SFP+ ports.
Caution To ensure the specified EMC performance, the length of any cable connected to the TRIG ports and REF CLK ports must be no longer than 3 m(10 ft). The length of copper cables connected to the SFP+ ports must be no longer than 3 m(10 ft). The length of cables connected to the USB device ports or host ports must be no longer than 30 m(100 ft). The lengths of Ethernet cables and optical SFP+ cables are not limited.
Caution The USB device port is intended only for use in device configuration, application deployment, debug, and maintenance.