Connector Pane:Set
- Updated2025-01-28
- 1 minute(s) read
Connector Pane:Set
Sets the connector pane of the VI to match the connector pane of the VI reference input.
Use this property to dynamically configure a VI connector pane to match the connector pane layout of an existing VI. The two VIs must have the same number of parameters with identical data types and names. If they do not, the Property Node returns an error. Use the Open VI Reference function to open references to both VIs and then wire those references to the Property Node and the Connector Pane:Set property input.
Remarks
The following table lists the characteristics of this property.
| Short Name | ConPane.SetConPane |
| Data type |  |
| Permissions | Write Only |
| Available in Run-Time Engine | No |
| Available in Real-Time Operating System | No |
| Settable when the VI is running | No |
| Loads the front panel into memory | Yes |
| Need to authenticate before use | No |
| Loads the block diagram into memory | No |
| Remote access allowed | Yes |
| Must wait until user interface is idle | Yes |
| Available with control VIs | No |
| Available with global VIs | No |
| Available with strict type definitions | No |
| Available with polymorphic VIs | No |